Track wheel hub Tandem T80T
The Tandem T80T track hub is optimized for ambitious athletes on the track.
Besondere Steifigkeit erhält die Bahnradnabe Tandem T80T, weil die Nabenflansche „hohl“ gedreht und nach innen geneigt sind. Damit sind die Flansche an den Speichenwinkel angepasst.
Bei doppelt gekreuzter Speichung liegen die aussen angeordneten Speichen exakt am Flansch an. Ein „Setzen“ der Speichen wird dadurch deutlich minimiert.
In addition, the spokes are not bent over the flange. This reduces the forces on the flange.
- Flange height 80 mm
- Aluminum
- without lockring
- Axle with M10x1
- Highly tempered and nitrided axle
- Adjustable bearing clearance
- Mass: 338 g
- Standard with 24 holes usually available from stock
- other numbers of holes are also available on request
Thread:
For historical reasons, there are different threads for track wheel hubs.
DIN, ISO and BSA threads have a flank angle of 60°
ITA thread has a flank angle of 55 degrees
The following thread variants are available from HEUER:
BSA 1.37″x24TPI
ITA M35x24TPI
ISO 1.375″x24 TPI on request.
The rear wheel hub for the track is manufactured by us without a lockring.
Attention:
Shimano is BSA
Campagnolo is ITA
Incorrect pinion threads can damage the threads.
Ensure that the threads are correctly paired (manufacturer)
English 
Deutsch 
Français